Einsatzgebiete

Removal of per- and polyfluoroalkyl substances

Vorteile

Buffered resin
Stable pH and CSMR* output
sehr hohe nutzbare Kapazität
exzellente kinetische Eigenschaften
Reduces PFAS to non-detect levels ranging from 1 – 5 parts per trillion

Systeme

komunal

Behördliche Genemigungen

Zertifiziert von der WQA nach NSF ANSI 61 Standard

Typische Verpackungen

1 CF Sack
25 L Sack
5 CF Papptrommel
1 M³ Big bag
42 CF Supersack

* CSMR = Chloride to Sulfate Mass Ratio

PFOA AND PFOS REMOVAL THROUGH ION EXCHANGE

Ion Exchange Resin Solutions: Treating Drinking Water For PFAS

APPLICATION GUIDE

PFAS Selective Single-Use Ion Exchange Resin for Drinking Water Systems

ONE SHEET

Purolite Buffered Resins

Typische physikalische & chemische Eigenschaften:

Polymerstruktur	Polystyrol quervernetzt mit Divinylbenzol
Aussehen	Spherische Kugeln
Funktionelle Gruppe	komplexes Amin
mittler Korndurchmesser	700 ± 80 µm
Uniformitätskoeffizient (max)	1.3
Spezifische Dichte	1.05
Schüttgewicht (ca.)	650 - 700 g/l (40.6 - 43.8 lb/ft³)
Temperaturlimit	100 °C (212.0 °F) (Cl-)
Temperaturlimit	60 °C (140.0 °F) (OH-)

Hydraulische Eigenschaften

Pressure Drop

The pressure drop across a bed of ion exchange resin depends on the particle size distribution, bed depth, and voids volume of the exchange material, as well as on the flow rate and viscosity of the influent solution. Factors affecting any of these parameters— such as the presence of particulate matter filtered out by the bed, abnormal compressibility of the resin, or the incomplete classification of the bed—will have an adverse effect, and result in an increased head loss. Depending on the quality of the influent water, the application and the design of the plant, service flow rates may vary from 10 to 40 BV/h.

Pressure Drop Across Resin Bed

Backwash

A 20 BV downflow rinse is required before the vessel is put into service. This rinse can be done onsite or offsite pre-installation. Once the resin is put into service, backwashing is not permitted as this will lead to shortened bed life. This is a uniform grade resin with beads of similar size and will not require backwashing for classification / stratification before use. If it is determined, before startup, that air bubbles or particulate matter are trapped within the bed, then backwashing can be done. In that case, the resin bed should be expanded by 50-70% for 10-15 minutes. Please note that bed expansion increases with higher flow rate and lower water temperature. Avoid loss of resin through the top of the vessel by over expansion of the bed.

Backwash Expansion of Resin Bed

Purofine™ PFA694EBF

Hier um zu helfen

Overview

Literature